BRAD / FINISH NAILS
T Series 17 Gauge T Head Nails
17 ga · 25–50 mm
Straight collated nails for furniture, trim and wooden assembly. Specify the head size, wire cross-section and tool model as well as length.
Gauge
17 ga
Length range
25–50 mm
Head width
2.9 mm
Wire width
1.57 mm
Wire thickness
1.25 mm
Material reference
Zinc-coated wire; grade to confirm
Pieces / strip
80
Availability, material grade, finish and tool compatibility will be checked for the requested configuration and stated in your quotation.
CATALOG REFERENCE DIMENSIONS
Sizes and series
Source-confirmed nominal inch labels are shown where documented. Unverified dimensions remain in the source unit; listed references do not imply every size combination is available.
T Series 17 Gauge T Head Nails · catalog reference sizes
Reference
Length (mm)
T25
25 mm / 1 in (nominal)
T32
32 mm / 1 1/4 in (nominal)
T38
38 mm / 1 1/2 in (nominal)
T50
50 mm / 2 in (nominal)
Choose a listed size and include it in your enquiry.
DEFINE THE ORDER, NOT JUST THE FASTENER
Packing, samples and order documentation.
Material and packing details
Parameter
Reference
Standard material reference
Zinc-coated wire
Alternative material enquiry
Stainless steel; specify grade
Fasteners per strip
80
Box / carton packing
Specify the required count; quoted for the selected size
Source feed-wire diameter
1.49 mm before forming
Source point angle
40°
Source zinc-layer reference
0.7–1.0 μm
Material and manufacturing figures are catalog references. Coating thickness is not a batch test result or a corrosion-life guarantee; stainless grade, tool fit and packing are confirmed with the selected size.
APPLICATION EXAMPLES
Where it's used
Explore the materials, joints and workshop tasks below. Match the fastener size and tool to your own workpiece before ordering.
Substantial decorative trim
Allow a suitable seating or filling location for the larger T-head profile.
Specified furniture wood components
Match T-head nails to the furniture component process and its accompanying joint details.
Thicker decorative frame sections
Trial the head seating and timber condition on the actual decorative section.
AI-generated application illustrations, not customer project photographs.
SIZE THE FASTENER FOR THE JOINT
Balance penetration and the visible fixing point.
Head
Nail length
Wire section
Width × thickness
Point
Measurement guide · schematic, not to scale. Refer to the listed dimensions and an approved order drawing.
Trim and joinery buyers need the head shape, wire cross-section and listed length, together with the exact brad or finish nailer. Test the fixing on representative material for holding, splitting and the required surface finish.
Choose for your workpiece and equipment
01
Use the actual 17GA specification
The reference lists 1.57 × 1.25 mm wire and 25, 32, 38 or 50 mm lengths. Do not relabel it as a standard 16GA finish nail.
02
Verify the nail and driver profile
Send the T-head drawing and tool model. A tool name beginning with T does not establish accepted gauge, head dimensions or strip geometry.
03
Test the timber and appearance
Check head seating, splitting, point breakthrough and component retention on production material. Approve the finishing result as well as the driven nail.
Questions before you order
Can these be ordered for concrete fastening?
The current reference does not establish hardening or masonry suitability. Concrete fastening requires a purpose-designed fastener and matched tool specification.
Will a 16GA T50 finish nailer accept them?
Do not assume so. This product is listed as 17GA; compare the complete fastener drawing with the tool manufacturer’s approved specification.
Application limits to check
- These are not confirmed hardened concrete or masonry T nails.
- Do not use the generic T name to claim roofing, structural or metal-stud suitability.
